Connector Panel - Sony HKDV-900 Bedienungsanleitung

8 FINE/FINE/H/V RATIO adjustment knob and
PRESET button
Carry out the following adjustment, according to the
output selection. Pressing the PRESET button returns
to the minimum value (the factory default setting), and
the "MIN" indicator lights. (When IMAGE
ENHANCER is selected the center value is selected.)
When HD is selected: Sync phase fine adjustment
(Coupled to the SYNC PHASE knob. One whole
turn of the FINE knob corresponds to a change of
one step in SYNC PHASE.)
When D1/D2 is selected: Sync phase fine adjustment
(Coupled to the SYNC PHASE knob. One whole
turn of the FINE knob corresponds to a change of
one step in SYNC PHASE.)
When IMAGE ENHANCER is selected: H/V
RATIO setting (ratio of horizontal and vertical
edge enhancement settings)

Connector panel

REMOTE OUT (TO VTR) 1/2/3/4 connectors
4
1 REMOTE OUT (TO VTR) 1/2/3/4 connectors
(D-sub, 9-pin)
Connect to the VIDEO CONTROL connector of the
HDW-500/F500/2000/M2000/A2100/M2100 or the
VIDEO CONTROL connector of a HKPF-series
boards. For the connection, use an optional RCC-5G/
10G/30G remote control cable.
Note
Using a cable other than specified above may cause
damage to this board or the connected device.
REMOTE OUT (TO VTR)
3 2
9 –/CROSS COLOR/GAMMA adjustment knob
and PRESET button
Carry out the following adjustment, according to the
output selection. Pressing the PRESET button sets the
center value (the factory default setting).
When HD is selected: Not used
When D1/D2 is selected: Cross color reduction
adjustment
When IMAGE ENHANCER is selected: gradient
of gamma correction curve
1
SEE
INSTRUCTION
MANUAL
7(GB)