Troubleshooting - Medion MD80410 Bedienungsanleitung

DVD-Porty 2TFT MD80410 D EN DK E.book Seite 31 Montag, 4. April 2005 12:56 12
T
ROUBLESHOOTING
If errors occur, check first whether you can correct the
problem yourself. The following overview may help
you.
Never try to repair the device yourself. Contact our
service centre or other qualified personnel if a
repair is necessary.
PROBLEM
GENERAL
No functions
No operation LED
The disc does not play
PLAY
even though
been pressed, or stops
again immediately
The unit does not
respond to the remote
control
POSSIBLE CAUSE / REMEDY
The power is not connected properly.
Pull out the plug and insert it again into the mains.
If the unit has been affected by a storm, static charging
or other external factor, try the following procedure:
Switch the device off. Then pull out the mains cable and
plug it back in.
The disc has not been inserted properly.
has Insert a disc into the disc compartment with the title side
upwards.
The disc is contaminated or damaged.
Clean the disc or test the device by inserting another
disc.
Condensed water has formed in the disc compartment.
Leave the disc compartment open for one to two hours
to allow it to dry out.
DVD: The wrong regional code (2) has been set.
Set the correct regional code.
The batteries are dead.
Replace the batteries.
The remote control is not pointing correctly to the
device.
If necessary remove any blockages between the remote
control and the device. Point the remote control at the
infrared sensor on the front of the device. It should not
be further than 3 m away from the device.
EN
EN-31