Using The Remote Contro - Medion MD80410 Bedienungsanleitung

DVD-Porty 2TFT MD80410 D EN DK E.book Seite 12 Montag, 4. April 2005 12:56 12
Insert the batteries into the remote control.
Using the remote control
EN-12
Do not expose the remote control to liquids
because this could damage it.
A button battery (CR2025) is supplied for the remote
control.
! To open the battery compartment press the clip on
the small handle inwards (1) and carefully pull the
battery compartment out (2).
! Insert the battery into the compartment so that the
plus pole (marked +) points upwards (3).
! Slide the battery compartment back into the remote
control. The clip should click back into place.
CAUTION!
The enclosed batteries must not be charged,
disassembled, thrown into fire or short-circuited.
There is the risk of an explosion.
! Direct the remote control
- either at the infrared sensor on the front of the
device
- or the infrared sensor on one of the monitors.
You can use the remote control from a distance of up to
around 3 m from the device.
The monitors can not be operated separately. The
signal is transferred from the monitor's sensor to the
device.