Setting The Speed; Changing A Disc; Use Of Accessories; Cutting / Roughing Discs - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

Switching off:
Release the ON / OFF switch
©

Setting the speed

Select the desired speed before use to suit your
purpose. Turn the speed preselector wheel
to the desired setting. The required rotational
speed depends on the material being worked
and the working conditions and can be deter-
mined by means of a practical test.
The table below shows some recommended
settings (for guidance only and given without
liability) for a number of common applications.
The accessories mentioned may not all be sup-
plied as standard with the product. Sawing stone
is only permitted with the use of a cutting guide
(accessory).
Preselected rotation speed:
Material Application
Plastic, Polishing
varnish
Fine finish
Metal Fine finish
Paint
removal
Wood, Brushing,
metal derusting
Metal, Grinding /
stone abrading
Metal Roughing /
grinding
Stone Cutting
Metal Cutting
©

Changing a disc

Always wear protective gloves
when changing cutting or roughing /
grinding discs.
again.
2
10
Tool Setting
Lambswool 1
bonnet
Felt polishing 1
disc
Buffing disc 1
Sanding sheet 2–3
Cup brush, 3
sanding sheet
Grinding disc 4–6
Roughing / 6
grinding disk
Cutting disc 6
and cutting
guide
Cutting disc 6
Use / Use of accessories
Press the spindle lock button
mounting spindle
7
Fig. A.
Press the spindle lock button
drive.
Release the clamping nut
, Fig. B.
11
Place the roughing, grinding or cutting disc on
to the mounting flange
facing towards the device.
Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
7
Press the spindle lock button
drive.
Tighten the clamping nut
spanner .
11
Note: Replace a new disc immediately if it runs
unevenly or vibrates after being exchanged.
After replacing a disc let the device run under
no load for 30 seconds as a safety check.
Look out for unusual noises or generation of
sparks.
Check that all the fastenings are correctly
attached.
Pay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
©

Use of accessories

©

Cutting / roughing discs

You can use the following cutting or roughing/
grinding discs with this device:
Dimensions:
Speed:
Circumferential speed: 80 m / sec
only after the
9
has reached a standstill,
to block the
9
using the spanner
6
with its labelled side
8
, with its
6
to block the
9
again with the
6
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
min. 12000 rpm
GB/MT 63