Towing / Trailering - Jacobsen R311T-T4I Sicherheits-, Betriebs- Und Wartungshandbuch

OPERATION 5

5.11 TOWING / TRAILERING _____________________________________________________

If the mower experiences problems and must be shut
down and removed from the area, it should be loaded
onto a trailer for transport. If a trailer is not available, the
unit can be towed slowly short distances.
NOTE: Do not exceed 2 MPH (3.2 KPH) while towing.
Long distance towing is not recommended.
Use care when loading and unloading mower. Fasten
mower to trailer to prevent mower from rolling or shifting
Normal
Brake
during transport.
Operation
Release
Position
Position
Before towing, open tow valve. The tow valve permits
moving the mower without starting the engine and
prevents possible damage to hydraulic components.
The tow valve (Z) is located on the drive pump beneath
Figure 5F
the seat. Remove hardware and tilt seat towards left side
deck.To open valve, use a small wrench to turn the valve
counterclockwise 90°.
The brakes must be manually released to allow the
mower to be moved. Remove access panel in floorboard
and rotate brake release lever to brake release position.
To release the brakes, turn steering wheel for right hand
turn until resistance is felt.
After towing, rotate brake release lever to closed position,
close tow valve completely and make certain seat and
access panel are closed and secured.
Normal
Operation
Z
Tow
Position
Figure 5E
en-33