Installation; Unpacking; Selecting The Right Place; Connecting The Power Cord - VWR STAR-BEATER Bedienungsanleitung

INSTRUCTION MANUAL

5. INSTALLATION

5.1. UNPACKING

Before the installation, carefully examine the delivery for possible damage or missing
parts.
Open the box and take the machine out of the box. Check that the machine has not been
visibly damaged during the transport.
Please keep the packing material for the duration of the guarantee period. In case of a
complaint and return of the machine in unsuitable packing material, your guarantee claim
will be lost.
Check that the mains cord is compatible with the local standard.
If any kind of damage occurred during transport, immediately make a complaint to the
carrier. Any incorrect delivery or missing parts should be reported to the distributor.

5.2. SELECTING THE RIGHT PLACE

When selecting the right place for the machine, please consider the following:
- Put the device on smooth, horizontal and stable place.
- Leave enough space beyond the device for normal air circulation, min. 10 cm.
- Leave enough space around the device, that you will easy control and maintain it.
- Don't use the device in surroundings, where there are fast temperature and humidity
changes. Also avoid places exposed to direct sunlight and places nearby heating
devices.
- Avoid places, where the possibility of shocks and vibrations exists.
Note: The machine should not be placed so, that it is difficult to pull out the cord
plug from mains power supply.

5.3. CONNECTING THE POWER CORD

The correct voltage and frequency for the Star-Beater are given on the name plate. Ensure
that these values correspond to the available power supply system.
Fit one end of the power cord, included in the delivery, into the mains socket on the
machine. Connect the other end of the cord to a grounded wall socket.
To avoid interference from noise, surges and spikes, a dedicated line is preferred. If no
such line is available, avoid lines to which powerful electric motors, refrigerators and
similar devices are connected.
The power can be turned on and off by the POWER switch, located on the right side of the
housing of the machine. Light in the switch indicates, when the power is on.
EN 8
VWR Star-Beater