Basic Operation - VWR STAR-BEATER Bedienungsanleitung

INSTRUCTION MANUAL

6.4. BASIC OPERATION

• Switch on the Star-Beater with POWER switch on the right side of the housing.
Setting the milling time
• TIME signal light shines. With rotating ENCODER right (+) or left (-), set the milling
time to required value from 5 sec to 99 min.
Examples: 98.5 ⇒ 98 min 50 sec
• If you want to set the time to hold (continued operation), set "HLd" on display. You
get message "HLd" on display, under time value 0.05 or above time value 99.0.
Setting the frequency
• Push ENCODER knob, so that FREQUENCY signal light shines. With rotating
ENCODER right (+) or left (-), set the vibrational frequency to required value from 3
to 30 Hz.
Example:
9.59 ⇒ 9 min 59 sec
0.59 ⇒ 59 sec
20.0 ⇒ 20.0/s
EN 12
VWR Star-Beater