Inhaltsverzeichnis
Werbung
I
NsTallaTIoN
1.
Important: Choose the space on your bench where the VWR High Speed
Micro Plate Shaker will stay. Because of the amount of energy dissipated,
the unit is held onto your lab bench with 12 rubber feet (suction cups). The
unit is VERY difficult to remove from work surface and should be done with
caution. Use paper under the feet to keep them from attaching to the bench
while determining the final location. When final location is determined,
remove the paper.
2.
Be sure the power switch is in the off position.
3.
The VWR High Speed Micro Plate Shaker comes with a connector plug that is
inserted into the IEC connector on the back of the unit first, then it can be
plugged into a properly grounded outlet. The 230v unit plugs into a 230 volt,
50/60 Hz source.
4.
Your VWR High Speed Micro Plate Shaker is ready for use.
M
& s
aINTENaNCE
ErvICINg
The VWR High Speed Micro Plate Shaker is built for long, trouble-free, dependable
service. No lubrication or other technical user maintenance is required. It needs no
user maintenance beyond keeping the surfaces clean. The unit should be given the
care normally required for any electrical appliance. Avoid wetting or unnecessary
exposure to fumes. Spills should be removed promptly. Do not use a cleaning agent
or solvent on the front panel which is abrasive or harmful to plastics, nor one which
is flammable. Always ensure the power is disconnected from the unit prior to any
cleaning. If the unit ever requires service, contact your VWR representative.
I
U
NTENdEd
sE
This shaker is intended for general laboratory use.
E
d
qUIPMENT
IsPosal
This equipment must not be disposed of with unsorted waste. It is
your responsibility to correctly dispose of the equipment at life-cycle-
end by handing it over to an authorized facility for separate collection
and recycling. It is also your responsibility to decontaminate the
equipment in case of biological, chemical, and/or radiological contami-
nation, so as to protect the persons involved in the disposal and recy-
cling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By
doing so, you will help to conserve natural and environmental resources and you will
ensure that your equipment is recycled in a manner that protects human health.
E
C
NvIroNMENTal
oNdITIoNs
Operating Conditions: Indoor use only.
Temperature:
4 to 40°C
Humidity:
20% to 80% relative humidity, non-condensing
Altitude:
0 to 2000 M above sea level
Non-Operating Storage:
Temperature:
-20 to 65°C
Humidity:
20% to 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
EN
2
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
