Control Panel Description - VWR STAR-BEATER Bedienungsanleitung

INSTRUCTION MANUAL
Position
1 Control panel with display
2 Hood
3 Milling jar holder - left
4 Milling jar holder - right
5 POWER switch
6 Mains socket
7 Fuse compartment

6.2. CONTROL PANEL DESCRIPTION

- POWER switch (on the right side of Star-Beater) - switches ON (power switch shines)
or OFF the power of the machine.
- RUN signal light (green) - shines when Star-Beater is running.
- TIME signal light (yellow) - shines when Star-Beater is set on time.
- FREQUENCY signal light (yellow) - shines when Star-Beater is set on vibrational
frequency.
- ENCODER knob (push or rotate) - with rotating ENCODER right (+) or left (-), you
change TIME or FREQUENCY on the machine. Push ENCODER to switch between
TIME and FREQUENCY setting values.
If you rotate ENCODER knob fast, then values on display go up or down quickly.
- START/STOP key - starts or stops the operation of Star-Beater.
Starting of the machine is possible only with the hood closed. If the
hood is open, message "LId" appears on display.
Always start and stop the machine with START/STOP key.
Description
Time and vibrational frequency setting,
starting / stopping the machine.
Closes the milling chamber.
Holds the milling jar.
Holds the milling jar.
For switching the Star-Beater on and off.
Connection for power cord to the machine.
Contains two fuses.
EN 10
VWR Star-Beater
Function