Installing The Device; Fix Of The Machine - Bosch TCE 60 Originalbetriebsanleitung

en 20 | TCE 60 | Commissioning
3.3

Installing the device

When you choose the installation position, you should
secure the safety of the machine when it runs in the
normal work condition.
i
This machine must be connect to the main and
compressed air system, hence we suggest you to
install the machine near the power source.
i
Installation position should at least leave the space
in the following figure to secure free movement of
each part of the machine.
i
If this machine is installed outdoors, you should take
measures to prevent rain and sun. General speaking,
this machine can not be used outdoors.
i
The work are should enjoy enough light to secure
the operators can observe each details of the
operation.
i
Besides the operator, when the machine is running,
any other personnel should not in the work area.
Fig. 3: Installing the device
|
1 695 108 075 2016-08-23
Fig. 4: Installing the device
3.4

Fix of the machine

i
Pay attention that the nozzle and air hose on the
machine should not be damaged during the move
1. Install the main parts of helper, install bolt, adjust
the angle of helper and make it at the same level
with tyre changer ,meanwhile the Pressor point to
turntable centre, after finish all the above process
then fasten the bolt.
Robert Bosch GmbH