Settings; Date & Time Settings - Apex MD300M Bedienungsanleitung

MD300M
3. The alarm setting can recover if the power-break time less than 30s.
4. Set the high parameter value with simulator to test the efficiency of the alarm system.
5. DO not set the parameter value out of the range, or the alarm system will failure.
6. The device can reserve alarm setting if it power break.
PULSE OXIMETER
- 16 -
INSTRUCTION MANUAL

4 Settings

Always set the date and time before using the unit for the first time. Set different ID
numbers for different users.
Check the date and time are correct before using the unit, and reset them if necessary. The
date and time are important indicators when a measurement is taken.
4.1 Date & Time Settings
Set the correct time according to the following steps:
1) Press the power switch for 3 seconds to power on the oximeter and then press the menu
button to enter the main menu, refer to the Fig.4-1.
2) Press the Navigation button to select "Date and Time" item, and then press the OK button
to enter the time setup screen, refer to Fig.4-2.
Press the Navigation button to select it and then press the OK button to confirm it. At last,
press the Navigation button adjust the value, and then press the OK button to confirm the
MD300M
Fig.4-1
Fig.4-2
- 17 -