Silvercrest SSRA1 Bedienungs- Und Sicherheitshinweise Seite 54

Troubleshooting
Reason
Left wheel malfunction
19
malfunction E12
Right wheel
19
Left brush malfunction
21
Right brush malfunction E14
21
Main brush malfunction E15
20
The robot vacuum cleaner
is not on the floor.
Anti-drop sensor
22
malfunction
Anti-collision sensor
24
malfunction
The robot vacuum cleaner
is stuck.
Fan malfunction
Battery malfunction
Anti-collision sensor
module malfunction
Gyro navigation module
error
Battery low
HEPA filter clogged
6
110 GB/MT
Display Signal tone
Beeps: once
E11
Beeps: once
Beeps: once
E13
Beeps: once
Beeps: once
E21 Beeps: two
Beeps: two
E22
E23 Beeps: two
Beeps: three
E31
Beeps: three
E32
E41 Beeps: three
Beeps: four
E42
Beeps: five
Solution
Check left wheel
19
Check right wheel
19
Check left brush
21
Check right brush
21
Check main brush
20
Move the robot vacuum cleaner
to a clear area and restart.
Check anti-drop sensor
Check anti-collision sensor
Move the robot vacuum cleaner
to a clear area and restart.
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Replace battery
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Restart the robot vacuum cleaner.
Please contact customer service
if you are unable to resolve the
problem.
Use the remote control to return
the robot vacuum cleaner to the
charging dock. If the robot vacuum
cleaner is on Standby, ensure it is
charged so it will always have
enough power to clean.
Clean HEPA filter .
6
22
24