Install The Waterproof Port; Attach The Hand Strap - Olympus PT-E03 Bedienungsanleitung

Install the Waterproof Port.

To enable the Case to be used underwater, the separately available Waterproof Port for the camera lens
must be installed on the Case. Align the Waterproof Port with the position where the camera lens will be
when the camera is loaded in the Case.
• Refer to the instruction manual provided with the Waterproof Port before attaching the Waterproof Port
to the Case.
• Apply the provided O-ring grease to the O-ring section of the Waterproof Port and the Waterproof Port
mounting thread on the Case.
• Screw the Waterproof Port into the Case by turning it clockwise all the way.
CAUTION:
The Case should not be used underwater at depths that exceed 40 meters. Even when the attached
underwater lens port or other equipment is able to withstand depths exceeding 40 meters, the Case itself
cannot be used at depths of more than 40 meters.

Attach the hand strap.

Attach the hand strap to the Case.
En
Hand strap
CAUTION:
• Be sure to install the hand strap correctly as shown above.
• Two hand strap rings are attached to the side of the Case, at the top and bottom of the palm grip. Before
using the Case, be sure to attach the ends of the strap to the two hand strap rings.
• OLYMPUS IMAGING CORP. shall bear no responsibility for damage caused by dropping the Case because
of incorrect installation of the hand strap.
EN 9
Waterproof Port mount thread
O-ring grease
Hand strap ring