Tylo SENSE PLUS Installationsanleitung Seite 20

6
12. Hang the heater on the brackets by sliding it straight in to-
wards the wall (see Figure 13, Page 6). It can be neces-
sary to slacken the bracket screws a little. Tighten them again
when the heater is hung up.
Figure 13: Sliding the heater on
13. Use the countersunk lock screw to prevent the heater being
lifted off the wall (see Figure 14, Page 6).
Figure 14: Lock screw
Unusual voltages/number of phases
Before connecting to voltages or numbers of phases not listed in
the wiring diagram Figure 15, Page 7, contact Tylö Customer
Service.