Tylo SENSE PLUS Installationsanleitung Seite 17

2. Position the sensor according to the diagram (see Figure 5,
Page 3).
3
2
1 1
Figure 5: Positioning the heater - niche installation
1. Minimum distance to side wall: 200 mm
2. Positioning the sensor: 200 mm from heater
3. Sensor
4. Max. 1000 mm
5. Positioning the sensor: 40 mm from ceiling, regardless of
ceiling height
6. Minimum distance to ceiling: 1200 mm
7. Minimum distance to interior fittings: 100 mm
8. Minimum ceiling height: 1900 mm
9. Minimum distance: 20 mm
10. Minimum distance to interior fittings: 30 mm
11. Minimum distance to floor (without legs): 100 mm
Positioning the inlet vent
Position the inlet vent straight through the wall under the
centreline of the heater. Vent size for a family sauna approx. 125
cm².
Air circulation from the door must merge with the hot air from the
heater.
5
6
7
4
8
10
9
11
1
3
Figure 6: Positioning the inlet and outlet vents
1. Inlet vent position.
2. Outlet vent position through the sauna wall.
3. Outlet vent position through the cavity.
4. Outlet vent position via duct.
Positioning the outlet vent
DANGER! The outlet vent must not lead outdoors.
!
This may affect the heater temperature cut-out as
the ventilation direction could be reversed.
DANGER! Any gap above the sauna ceiling should
!
not be sealed without leaving at least one vent hole
on the same wall as the sauna door!
Position the outlet vent:
• with maximum distance to the inlet vent, e.g. diagonally (see
Figure 6, Page 3).
• high on the wall or in the ceiling (see Figure 6, Page 3).
• so that it vents into the space the door and inlet vent open in-
to.
The outlet vent must have the same area as the inlet vent.
Ensure that the outlet vent is open.
Mechanical ventilation is not recommended, because of the risk
of poor air exchange, which can have a negative effect on the
heater temperature cut-out.
3
2
4