Playing A Cd Or Md; Recording Audio From Cinemastation - Yamaha DVX-S200 Bedienungsanleitung

Playing a CD or MD

AMP
DVD/CD
VCR
MD/CD-R TUNER
MD/CD-R
MOVIE MUSIC SPORTS
CINEMA

Recording Audio from CinemaStation

DVR-S200 WB56620
POWER
POWER
AUDIO ANGLE
/DTS SELECT MATRIX 6.1
REPEAT
NIGHT
SW CENTER
AMP
DVD/CD
VCR
MD/CD-R TUNER
MOVIE MUSIC SPORTS
CINEMA
Advice
• When using Timer Playback/Recording, even if CinemaStation is in standby mode, the memory content (e.g. input source, AM/
FM frequency) is retained and used.
Notes
• Even if you use DTS software to digitally record a DTS signal only noise will be recorded.
• CinemaStation cannot output a Super Audio CD signal to the digital jack.
• If you want to perform Timer Recording without hearing sound, turn the volume down before starting Timer Recording.
Read the owner's manual of the equipment you want to
operate before using it.
VIDEO 1
• The Remote Control can operate a CD or MD recorder connected to
VIDEO 2
GAME
POWER
TV
SUBTITLE
STEREO
A-B
SURR
SHIFT
VIDEO 1
Input
Selection
VIDEO 2
buttons
GAME
Advice
CinemaStation. However, it is first necessary to enter the
manufacturer code for the equipment in the Remote Control's
memory. See page 84, "Storing Manufacturer Codes in the
Remote Control".
Turn on the CD recorder or MD recorder.
Press POWER to turn on CinemaStation.
Press MD/CD-R.
CinemaStation can now output audio signals received
from a CD or MD recorder.
Start playback on the CD or MD recorder.
Turn on the CD recorder or MD recorder power
and get ready for recording.
Press POWER to turn on CinemaStation.
Switch CinemaStation input to the source you
want and start playback.
E.g. To play a CD: First press DVD/CD then play the CD.
Start recording with the CD recorder or MD
recorder.
Using Other Equipment
53