Electronic Control Unit; Table Displaying Pages And Parameters Of The "Pumps Controller - DAB E1GI Installations- Und Wartungsanleitungen

14.
TABLE DISPLAYING PAGES AND PARAMETERS IN THE
Pages Displayed
Main page displaying:
SetPoint 00,0 P 00,0
EP xxxx ON OFF EXT
Main page displaying:
SetPoint 00,0 P 00,0
EP xxxx OFF OFF EXT
Main page displaying:
SetPoint 00,0 P 00,0
EP IIII ON
2 pages displaying:
Q. : 0(L/M)
QT. : 000(L)
3 pages displaying:
kW : 0.0
kWh. : 0.0
4 pages displaying:
P1h : 0 MAN OFF
P2h. : 0 MAN OFF
P3h. : 0 MAN OFF
P4h. : 0 MAN OFF
5 pages displaying:
Software vers.
DAB 001059052
6 pages displaying:
Insert Key
(Dab Standard key)
or
(Dab Extended key)
(*) = only contemplated. It is necessary to connect the flow rate – current – voltage sensors (see table 17).
ENGLISH

ELECTRONIC CONTROL UNIT

SetPoint = Calibration pressure
P = System pressure
EP xxxx ON = the pumps are not enabled by the panel switches
OFF EXT = remote control disabled
SetPoint = Calibration pressure
P = System pressure
EP xxxx OFF = consent to access all the parameters with password
OFF EXT = remote control disabled
SetPoint = Calibration pressure
P = System pressure
EP xxxx ON = the pumps are enabled by the panel switches
Q = instantaneous flow rate (*)
QT = total flow rate (*)
kW = instantaneous power absorbed by the set (*)
kW = total power absorbed by the set (*)
h = pump work hours
MAN OFF = indicates that the pump has not exceeded the maintenance
hours
MAN ON = indicates that the pump has exceeded the maintenance hours
DAB customised software
10009
contact Dab Service
42
"PUMPS CONTROLLER"
Description of Parameters