Assembly; Preliminary Measures Before Start Up; Unit Setup; Start Up - Silvercrest SHH 1200 D2 Bedienungs- Und Sicherheitshinweise

Assembly


Remove all packaging material and all transport
protection locks from the unit.
A
Place the halogen heating unit on its rear side.
B
Guide the connecting cable
recess in the base
15
C
Loosen the two tommy screws
Place the base so that the three screws fit perfect-
9
ly into the three cavities. Ensure that the connecting
cable is routed through the lower recess
12
through the
12
.
9
from the base
9
13
.
15
D
Attach the base
using the two tommy screws provided.
13
E
Guide the connecting cable
clamp and the recess in the base
P reliminary measures before


start up

Unit setup


To guarantee safe and trouble-free unit operation, choose
a setup location which meets the following requirements:
- The floor should be firm, flat and horizontal.
- Observe the following minimum clearances
from the unit housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and 50
cm from its front side.
. - Do not place the unit in a hot and wet or very hu-
mid environment or near combustible materials.
- The socket should be easily accessible so that
the mains connection cable can be easily dis-
connected if necessary.
to the halogen heating unit
9
through the cable
12
.
15
GB/MT 47