Copyright; Prior To Use; Assembly (Figure D); First Use - Silvercrest SHH 1200 C1 Bedienungs- Und Sicherheitshinweise

SilverCrest SHH 1200 C1

7. Copyright

All information contained in these instructions is subject to copyright and is provided for information
purposes only. It is only permitted to copy or duplicate data and information with the express and
written consent of the author. This also includes commercial use of the content and data. The text
and illustrations are based on the state of the art at the time of printing.

8. Prior to use

8.1. Assembly (figure D)


Place the device facing upwards on a table or worktop so that approx. 10cm of the bottom of
the device and the safety switch (17) protrude over the table or edge of the worktop.

Take the heater base (9) and insert the mains cable (11) from above through the middle
opening in the heater base (9).

Then place the heater base (9) on the heater in such a manner that the mains cable terminal
(15) points to the back of the device. The spacers (14) must then lie above the 2 threads (16).

Then use the 2 fixing screws (13) to attach the heater base (9) to the heater. Tighten the 2
fixing screws (13), using a suitable screwdriver if necessary.

Press the mains cable (11) into the mains cable terminal (15) and then insert it into the opening
in the heater base (9) in such a manner that it emerges towards the back of the device.

This completes the assembly of the heater.

9. First use

DANGER! The temperature of the accessible surfaces may be very high when the device
is operating. There is a risk of burns!
DANGER! Always unwind the entire mains cable (11). It poses a fire hazard.
The device may briefly emit an odour or light smoke when it is used for the first time. This is
normal and completely harmless. If necessary, ensure that there is sufficient ventilation.

Insert the mains plug into an earthed mains socket that is always easily accessible and
conforms to the specifications in the "Technical data" section.
56 - English