Assembly; Initial Operation - Silvercrest SOR 1500 A1 Bedienungsanleitung

Assembly

GB
Use the fold-out page of these instructions to assist
IE
you with assembly.
1) Remove the oil radiator and all components from
the box and remove all packaging materials.
2) Place the oil radiator, with the base uppermost,
on a soft surface, for example a carpet.
3) Place the mounting bracket 6 under the
heater element so that the threaded parts
project upwards.
4) Lay a roller rail 7 over it, such that the screw
threads protrude through the holes. Check to
ensure that the recesses on the roller rails 7
are facing outwards. The screw ends project-
ing from the appliance must reach into the
recesses.
5) Screw one wing nut 8 hand tight onto each of
the threaded ends of the mounting bracket 6.
6) Lay the second roller rail 7 over the two
threaded rods that protrude from the control
panel so that they project through the holes in
the roller rail 7. Ensure that the small recesses
on the side of the roller rail 7 face inwards.
The screw ends that project from the appliance
must grip into the recesses.
7) Attach the roller rail 7 by screwing one wing
nut 8 onto each of the threaded rods.
8) Turn the appliance over and place it on the rollers.
6
All manuals and user guides at all-guides.com

Initial operation

1) Unwind all of the power cable from the power
NOTE
►
2) Insert the plug into a mains power socket.
3) Set the heat level switch 3 to "3" and the
NOTE
►
4) When the desired room temperature has been
5) If you want to switch off the appliance, turn the
6) Remove the plug from the mains power socket.
cable retainer 5.
Ensure that the thermostat 2 and the heat
level switch 3 are standing at MIN resp. 0.
thermostat 2 to MAX. The "Power" control
lamp 1 illuminates.
You can use the heat level switch 3 to regu-
late how quickly the appliance warms up.
If you wish to heat it up particularly quickly,
select heat level "3", if a slow warming up is
preferred, select heat level "1".
Using the thermostat 2 you can set it to the
desired temperature.
reached, slowly turn the thermostat 2 back
down until a quiet "click" is heard and the
"Power" control lamp 1 goes out. The current
room temperature will now be retained. The
"Power" control lamp 1 will light up occasion-
ally then switch back off after a short while.
This merely means that the programmed room
temperature has fallen below this level for a
short period and the appliance has warmed
itself back up.
heat level switch 3 to "0" and then the thermo-
stat 2 to MIN.
SOR 1500 A1