Setting Up; Lubrication; Connecting To A Compressed Air Source; Switching On And Off - Parkside PDTS 6.3 B3 Originalbetriebsanleitung

Setting up

Lubrication

WARNING!
► Avoid eye and skin contact with lubricants.
NOTE
► Regular lubrication is particularly important
to avoid friction and corrosion damage.
We recommend using a suitable special oil
for compressed air tools (e.g. Liqui Moly
compressor oil).
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously
and optimally lubricates the grinder as
a preparation stage after the pressure
reducer. A mist oiler gives off fine drops of
oil into the air flow and thus guarantees a
regular lubrication.
–
Manual lubrication
If you do not have a mist oiler, lubricate the
tool before every use or during longer work
sessions. Add 3–5 drops of pneumatic oil
into the connector nipple
Connecting to a compressed
air source
NOTE
► Before connecting the compressed air source
–
the correct working pressure (6.3 bar)
must be fully reached, and
–
you must ensure that the trigger is in the
upper position.
► Use only connection hoses with an internal
diameter of at least 9 mm.
► Use only filtered, lubricated and regulated
compressed air.
♦ Attach the tool to a compressor by connecting
the connector nipple
the compressed air source.
PDTS 6.3 B3
.
to the supply hose on
ATTENTION!
► Ensure that the compressed air hose is firmly
attached. A loose hose can thrash about
uncontrollably, causing serious danger.
Likewise, ensure firm seating of the two screw
connections between the coupling piece and
the tool.
♦ To ensure that you can regulate the air pressure,
the compressed air source must be equipped
with a pressure reducer.
Switching on and off
Switching on
♦ Press the switch-on guard
the blade guard
turn on the appliance.
Switching off
♦ Release the trigger
♦ When you have finished working, disconnect
the appliance from the compressed air source.

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from
the compressed air supply.
ATTENTION!
► Before maintenance, clean off any hazardous
substances which may have accumulated on
the tool (due to working processes). Avoid
all skin contact with these substances. If the
skin comes into contact with hazardous dusts,
this can lead to severe dermatitis. If dust is
produced or swirled up during maintenance,
it can be inhaled.
NOTE
► To ensure correct functioning and long-term
durability of the appliance, pay attention to
the following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functioning.
■ Check the speed and vibration levels after each
use.
in the direction of
. Then press the trigger
.
GB │ CY │
to
9 ■