Diesel Engine; Lighting System; Scrapping - Nilfisk RS 2200 Betriebsanleitung

ENGLISH
Problem

DIESEL ENGINE

When turning the ignition key, the engine does
not start

LIGHTING SYSTEM

The high and low beams do not turn on
The working lights do not turn on

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Brooms
– Engine oil
– Engine oil fi lter
– Hydraulic system oil
– Hydraulic system oil fi lters
– Plastic components
– Electrical and electronic components
NOTE
Refer to the nearest Nilfi sk Center especially when scrapping electrical and electronic components.
50
USER MANUAL
The battery release switch is deactivated
The gear selector is engaged
The working mode switch is enabled
The power supply fuse is open
The starting relay is damaged
The machine has run out of fuel
There is water in the fuel fi lter
There is an open in the light fuse
There is an open in the light switch
The bulbs are broken
The light control unit is damaged
The combination switch is broken
The working mode is not activated
There is an open in the light fuse
There is an open in the light switch
The bulbs are broken
33019476(3)2010-02 A
Possible cause
RS 2200
Remedy
Activate
Turn it to neutral
Disable
Replace the fuse
Replace the relay
Refuel
Bleed the system
Replace
Replace
Replace
Replace
Replace
Activate the working mode switch
Replace
Replace
Replace