Steering System; Brake System - Nilfisk RS 2200 Betriebsanleitung

ENGLISH
Problem
DUST CONTROL SYSTEM NOZZLES
No water from the nozzles
No water to the nozzles
The water pump does not stop

STEERING SYSTEM

The steering is hard

BRAKE SYSTEM

The machine brake system is not effi cient
The parking brake is not effi cient
STABILITY
When the machine moves the stability is
reduced
48
USER MANUAL
The nozzle holes are clogged
The nozzle holes are dirty
The working mode is not activated
The water tanks are empty
The water pump switch is off
The high-pressure valve is closed
The fl oat is stuck
The water fi lter is clogged
The by-pass on the control valve is open
The pressure is too low
The power supply fuse is open
The hoses are broken
The pump does not operate
The fl oat is stuck
The fl oat is not properly installed
The power steering is faulty
The priority valve is faulty
The rear wheel hydraulic control cylinder is
faulty
The brake fl uid is insuffi cient
The braking masses are worn or greasy
There is air in the line
The drum brake cylinder is faulty
The brake fl uid pump is faulty
The brake is misadjusted
The tyre pressure is incorrect
The rubber dampers are damaged/missing
The load has not been properly distributed
33019476(3)2010-02 A
Possible cause
RS 2200
Remedy
Clean
Clean/replace
Activate the working mode switch
Fill the tanks
Turn on
Open
Repair
Clean/replace
Close
Calibrate the control valve
Replace
Repair
Repair/replace
Repair
Install properly
Replace
Replace
Replace
Check the brake fl uid level
Replace
Bleed the system
Replace
Overhaul
Adjust
Check the tyre pressure
Replace
Distribute the load properly