Usage; Attaching The Cuff - Beurer BM 49 Gebrauchsanweisung

Volume level Vo1 flashes on the
display.
• You can set the volume of the
selected language using the
function buttons :
Vo3 = loud
Vo2 = medium
Vo1 = quiet
Confirm your selection with the
memory button .
6.3 Operation with the mains part
You can also operate this device with a mains part (not included in
delivery). The mains part can be obtained from specialist retailers or
from the service address using order number 071.95. However, before
connecting the device with the mains part, please ensure that you have
removed the batteries from the device. During mains operation, there
must not be any batteries in the battery compartment, as this could
damage the device.
• To avoid any potential damage, the device may only be operated
with a mains part that meets the specifications described in section
"12. Technical specifications".
• Furthermore, the mains part must only be connected to the mains
voltage that is specified on the type plate.
• Insert the mains part into the connection provided for this purpose on
the right-hand side of the blood pressure monitor.
• Then insert the mains plug of the mains part into the mains socket.
Voice output
• After using the blood pressure monitor, unplug the mains part from
the mains socket first and then disconnect it from the blood pressure
monitor. As soon as you unplug the mains part, the blood pressure
monitor loses the date and time setting but the saved measured values
are retained.

7. Usage

Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right arm.

7.1 Attaching the cuff

Place the cuff onto the bare upper arm. The
circulation of the arm must not be hindered by
tight clothing or similar.
The cuff must be placed on the upper arm so
that the bottom edge is positioned 2 – 3 cm
above the elbow and above the artery. The
line should point to the centre of the palm.
Tighten the free end of the cuff, but make sure
that it is not too tight around the arm and close
the hook-and-loop fastener. The cuff should
be fastened so that two fingers can still fit
under the cuff.
80