Safety Functions - Parkside PKS 2200 A1 Originalbetriebsanleitung

GB MT
Damaged protective devices and parts
have to be repared or changed except
as noted otherwise in this manual.
• It is recommended that a first-time user
at least practice the cutting of logs on a
saw log or frame.
• Use only approved mains cables of type
H05RN-F that are not more than 75 m
long and that are designed for outdoor
use. The wire cross section of the mains
cable must be at least 2.5 mm
roll out the cable reel completely before
use. Check the mains cable for damages.
• Warning! During operation, this power
tool produces an electromagnetic field.
Under certain circumstances, this field
may negatively affect active or passive
medical implants. In order to reduce the
danger of serious or fatal injuries, we
recommend that individuals who wear
medical implants should consult their
doctor and the manufacturer of the im-
plant before operating the machine.
• For sowing work on hillsides, always
stand in the area above the log. To
keep total control while sawing through,
reduce the pressure at the end of the
cut without loosening your grip on the
handles of the electric chain saw. Make
sure the saw chain does not touch the
ground. After finishing the cut, wait until
the electric chain saw comes to a halt
before removing it. Always shut off the
engine of the electric chain saw before
switching between trees.
• Dirt, stones, loose bark, nails, clips and
wires must be removed from the tree.
• Follow the maintenance, control and ser-
vice instructions in this manual carefully.
Damaged safety equipment and parts
must be repaired or replaced profes-
sionally by our service centre, unless
otherwise indicated in the operating
instructions.
68

Safety functions

A
. Always
2
1 Rear grip
with hand guard (10)
Protects the hand against branches
and boughs in the case of spring-
ing away by the chain.
3 Chain braking lever/
hand guard
Control system, which stops the
saw chain immediately in case of
a spring-back; lever can also be
activated manually; protects the
left hand of the operator if it slides
from the front grip.
The motor cannot be turned on if
the chain brake has engaged.
5 Saw chain with small
spring-back
Helps you to catch spring-backs
with specially developed control
systems.
17 Metal stop claw
Reinforces the stability when
vertical cuts are carried out and
facilitates sawing.
15 Electric motor
Double insulated for safety
reasons.
13 On-off switch with safety
chain brake
On releasing the On/Off switch,
the device immediately switches off.
14 Switch-on block
The switch-on block must be
released for switching on the
device.
18 Chain catcher
Decreases the danger of injuries
the chain breaks or if it comes off.
if