Assembly; Mounting The Saw Chain And Blade; Tensioning The Saw Chain - Parkside PKS 2200 A1 Originalbetriebsanleitung

Assembly

Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself -– injury hazard!
Before putting the electric chain saw into
operation, you must:
- install the blade, saw chain and chain
cover where necessary,
- adjust the saw chain tension,
- pour in chain oil,
- check the function of the chain brake
and the automatic oil pump.
Mounting the saw chain
and blade
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (14) anti-
clockwise (
sprocket chain wheel covering (8).
3. Spread the chain (5) out into a loop
with the cutting edges running clock-
wise .
4. Slide the saw chain (5) into the bar
guide groove. To mount the guide bar
(4), raise it to an angle of approx.
45 degrees. This will make it easier
to replace the saw chain (5) onto the
sprocket (24).
5. Place the chain bar (4) and saw chain
(5) on the bar bolts (23). When the
nose on the right below the bar bolt
(23) sits in the round recess on the
blade, the blade is placed correctly. It
is normal for the saw chain (5) to sag.
It is normal that the saw chain (5) is
slack.
) to remove the
6. Pre-tension the saw chain (5) by turning
the screw for the chain quick-tensioning
system (9) in clockwise direction.
7. Position the sprocket chain wheel covering
(8). First place the tab (25) on the cover
into the corresponding notch on the
plate (8). Tighten the fastening bolt (7).
Note that the saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its
side or on the head. This is a normal
process due to the necessary ventilation
opening on the upper edge of the tank and
does not constitute a reason for complaint.
As each saw is checked during production
and tested with oil, a small residue may
be in the tank despite draining, which may
slightly dirty the housing with oil in transit.
Please clean the housing with a cloth.
Prior to changing the chain, the nut of the
guide rail must be cleaned of dirt because
dirt deposits available can cause the chain
to break out of the rail. The deposits can
also absorb the chain oil. So the conse-
quence would be that the chain oil would
not or only a small part of it would reach
the underside of the rail and the lubrication
would be reduced.

Tensioning the saw chain

Regularly tightening the saw chain provides
safety for the user and reduces and/or pre-
vents wear and chain damages. Before the
start of work and in approx. 10 minute inter-
vals, we recommend the user to examine the
chain tension and correct it, if necessary.
The chain warms up when working with
the saw and thus expands slightly. These
"expansions" can be expected especially
from newer chains.
GB MT
69