Maintaining The Chain Bar; Turn The Chain Bar; Storage - Parkside PKS 2200 A1 Originalbetriebsanleitung

GB MT

Maintaining the chain bar

F
Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the saw and pull out the
power plug (12).
2. Remove the sprocket chain wheel cov-
ering (8), the saw chain (5) and the
chain bar (4).
3. Check the chain bar (4) for wear. Re-
move burrs and straighten the guide
surfaces with a fl at fi le.
4. Clean the oil passages (
the chain bar, in order to guarantee
a trouble-free, automatic oiling of the
saw chain during operation.
5. Mount chain bar (4), chainsaw
(5) and sprocket chain wheel covering
(8) and tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.
78
F
The blade (4) has to be reversed regularly
after a working time of approximately 10
hours in order to ensure even wear.
26) of
Use the graphical symbol below the chain
sprocket cover (8) as a guide to the align-
ment of the saw chain (5) when the blade
is rotated. The illustrated direction of travel
on the blade is no longer true.

Storage

•
•
•
•

Turn the chain bar

Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the saw and pull out
the power plug (
2. Remove the sprocket chain wheel
covering (8), the saw chain
(5) and the chain bar (4).
3. Turn the blade around its hori-
zontal axis and install the blade
and chain as described under
"Installing the sawing chain and
blade".
When doing so, pay attention to
the correct rotation direction of
the saw chain!
Direction of travel of the
saw chain
Clean the device prior to storage.
Empty the oil tank prior to longer periods
of non-use. Dispose of used oil in an
environmentally-responsible way (see
„Disposal/Environmental Protection").
Attach the protective blade cover.
Store the device in a dry and dustproof
location and out of reach of children.
12).
A