Before Use; Fitting/Changing The Sander Plate; Selecting A Sanding Sheet; Fitting The Sanding Sheet - Parkside PMFS 200 C3 Originalbetriebsanleitung

Before use

Fitting/changing the sander plate

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance .
♦ Use the appropriate sander plate
the corresponding application .
♦ Remove the four screws
hex key .
4a
♦ Remove the pre-fitted sander plate .
NOTE
The orbital sander plate
the appliance in one direction . Please pay at-
tention to the arrow marks on the orbital sander
plate . These must point forwards . With the
delta sander plate
♦ Now fit the required sander plate . Ensure that
the mounting plate B is aligned with the sander
plate . The threaded holes of the mounting plate
B must be aligned with the corresponding holes
on the respective sander plate . Align the rubber
pins A (only on sander plates
with the holes in the appliance (see fig . 1) .
A
B
Figure 1
♦ Replace the four screws
♦ Check that the sander plate is fitted securely .
■ 42 │ GB │ MT
using the supplied
can only be fitted to
the tip points forwards .
and
using the hex key

Selecting a sanding sheet

Removal and surface:
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet .
♦ Please note that you need to use appropriate
sanding sheets with different grains for working
for
different materials .

Fitting the sanding sheet

WARNING!
► Always remove the plug from the mains
power socket before carrying out any work
on the appliance .
NOTE
► Before fitting a new sanding sheet, remove any
dust and dirt from the sander plate
Attaching sanding sheets using Velcro:
♦ You can attach the sanding sheet to the sander
plate
♦ Ensure that the extraction holes on the sanding
sheet match up with those on the sander plate .
)
Removing sanding sheets fitted using Velcro:
♦ Simply pull the sanding sheet off the sander
plate
Attaching sanding sheets without using
Velcro (see fig. B on the fold-out page, not
supplied):
♦ Open the two clamping levers
♦ Push the sanding sheet under the open clamp-
ing rail at one end and clamp it firmly in
place with the clamping lever .
.
4a
♦ Follow the same procedure at the other end .
using Velcro .
(see fig . A on the fold-out page) .
.
PMFS 200 C3
.