Transportation And Storage - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch

Transportation and storage

3
3.1 Lifting and transporting
Danger of crushing and cutting!
Danger of crushing and cutting of body parts due to tipping or falling loads
during transportation.
1. The G-BH2 may only be transported horizontally.
2. The load-bearing capacity of the lifting gear and load-handling devices must
correspond to the Weight of the G-BH2.
3. Secure the G-BH2 to prevent it from toppling or falling.
4. Do not remain under supported loads.
5. Set the G-BH2 down on a horizontal surface.
Mechanical damage!
G-BH2 can be damaged during transportation due to impacts, tipping or
falling over.
1. The G-BH2 should not be exposed to impacts and blows during transporta-
tion.
 maximum linear acceleration: 1g
2. Secure the G-BH2 from tipping or falling over.
Preparing the G-BH2 for transportation
!
All multi-stage G-BH2 are equipped with a lifting attachment (item 058). The
lifting attachment is exclusively designed for the mass of the G-BH2, includ-
ing the original accessories (except for the in-line filter, item X). Spring ele-
ments (item Y) and additional silencers (item Z) can be damaged during
transportation.

Detach fitted in-line filter (item X), spring elements (item Y) and additional si-
lencers (item Z) before transportation of the G-BH2.
The 030 on the compressor cover (item Structure, G-BH2) must be placed hori-
zontally on the compressor foot before transportation (item 062, Structure).
1. Place the G-BH2 on a non-slip substructure.
2. Place the lifting strap between the compressor housing (item 002, Structure)
and foot around the motor (item 001, Structure).
3. Lift the G-BH2 until the lifting strap is taut.
4. Tilt the G-BH2 with two people on the compressor foot.
Transportation with a crane
1. Check that the lifting attachment is firmly fastened and retighten as neces-
sary.
2. Attach the crane hook to the lifting attachment.
3. Lifting and transporting the G-BH2.
4. Place the G-BH2 down and, if necessary, secure from slipping and falling.
5. Remove the crane hook after transportation.
Transportation and storage
WARNING
NOTICE
9 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
3
09.2013 · 610.44495.40.330