Assembly Of Integrated Frequency Inverter 2Fc4; 1St/Pb/Cb/Sc - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

11 Assembly options
610.44495.40.330 · 09.2013
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
11.5

Assembly of integrated frequency inverter 2FC4..3-

1ST/PB/CB/SC

▪ Insert the gasket (643) into the adapter plate (648).
▪ Place the adapter plate (648) on the terminal box opening of the motor hous-
ing (001) with an overhang on the ventilation side.
▪ Insert the screws (642) into the holes of the adapter plate (648) and screw
them to the terminal box in the motor housing (001).
M = 4.2 – 5.0 Nm (3.10 – 3.70 ft lbs)
A
▪ Position the terminal board (650) on the adapter plate (648).
▪ Secure the terminal board (650) and the adapter plate (648) using the screw
(651).
M = 4.2 – 5.0 Nm (3.10 – 3.70 ft lbs)
A
▪ Wire all electrical connections to the terminal board (650) according to the
marks or the circuit diagram.
▪ Insert the gasket (600G) into the hood (600D).
▪ Position the hood (600D) on the adapter plate (648).
▪ Screw the hood (600D) and the adapter plate (648) using screws (637).
M = 7.5 – 9.0 Nm ( 5.55– 6.65 ft lbs)
A
▪ Plug the frequency inverter (600) into the hood (600D) from above with over-
hang on the ventilation side.
▪ Screw the frequency inverter (600) and the hood (600D) using screws (638).
M = 18 – 22 Nm (13.3 – 16.2 ft lbs)
A
▪ Wire all electrical connections to the frequency inverter (600) according to the
marks or the circuit diagram.
▪ Position the frequency inverter cover (600C) on the frequency inverter (600).
▪ Plug the toothed washer (600W) onto the screw (600S).
▪ Screw the frequency inverter cover (600C) and frequency inverter (600) in us-
ing screws (600S).
Complete the assembly using Testing [➙ 66].
64 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
© Gardner Denver Deutschland GmbH