Mounting; Fitting On The Ventilation Side - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.1

Fitting on the ventilation side

▪ Fill the new radial shaft seal ring 100% with grease.
▪ Apply grease to the entire surface of the sealing lip of the radial shaft seal ring
(452) using a brush.
▪ NOTICE! Note the installation position of the radial shaft seal ring (452)!
▪ Press the radial shaft seal (452) into the end plate (450).
▪ Apply grease to the entire surface on both sides of the spring washer (467).
▪ Place the spring washer (467) in the end plate (450).
▪ Apply sealant Epple 03213 to the ventilation side sealing surface of the motor
housing (001).
▪ Insert the nuts (459) into the ventilation side pockets in the motor housing
(001).
▪ Position the end plate (450) on the motor housing (001).
▪ Align the holes of the end plate (450) and motor housing (001).
▪ Secure the end plate (450) and bracket (453) to the motor housing (001) using
the screws (451).
▪ Hang the lifting device into the lifting eyes of the motor housing (001).
▪ Lift the motor housing (001) and insert into the assembly device (A) with the
ventilator side facing down.
▪ If necessary, secure against slipping and tipping.
▪ Remove the lifting device.
39 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch

Mounting

9
09.2013 · 610.44495.40.330