Disassembly Of The Compressor Housing - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

Disassembly 8
8.9

Disassembly of the compressor housing

▪ Undo the screws (025) and remove with the washer (024).
▪ Remove the nuts (028) and washers (128) on the intermediate flange.
▪ Pull off the compressor housing (002) from the intermediate flange (026).
▪ Remove the dowel pin (071).
▪ Remove the radial shaft seal (096) from the compressor housing (002) and
note the installation position.
35 / 67
© Gardner Denver Deutschland GmbH 09.2013 · 610.44495.40.330
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch Tel. 071 918 60 60, Mail: v-g@prematic.ch