Assembling The Rolling Bearing On The Compressor Side - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

9 Mounting
610.44495.40.330 · 09.2013
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.8

Assembling the rolling bearing on the compressor side

▪ Push the washer (013) onto the rotor (005) in the marked installation position.
▪ Push the end plate (010) onto the rotor (005) in the marked installation posi-
tion.
▪ Fill the cavity in the compressor side rolling bearing (007) with grease, accord-
ing to the following table.
Type
2BH20360-3
2BH20540-3
2BH20780-3
▪ Grease the washer (069) on both sides and put onto the screw (029)
▪ Fit the washer (078) onto the screw (029) in the marked installation position.
▪ Grease the inner ring of the rolling bearing (007) and bearing seat of the shaft
(005).
▪ Put medium strength threadlocker onto the thread of the screw (029).
▪ NOTICE! Note the installation position of the rolling bearing (007), the
open side facing up (in the direction of the compressor cover)
▪ Tighten the rolling bearing (007) with screw (029).
[g]
8.6 – 10.5
7.1 – 8.6
17.1 – 20.9
48 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
[oz]
0.303 – 0.370
0.303 – 0.370
0.603 – 0.737
© Gardner Denver Deutschland GmbH