Fitting The Compressor Housing - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.3

Fitting the compressor housing

▪ Fill 100% of the new radial shaft seal ring (096) with grease and grease the
seat of the radial shaft seal ring (002).
▪ Apply grease to the entire surface of the sealing lip of the radial shaft seal ring
(096) using a brush.
▪ NOTICE! Note the installation position of the radial shaft seal ring (096)!
▪ Insert the radial shaft seal (096) into the compressor housing (002).
▪ NOTICE! Note the position of the motor housing (001) with respect to the
compressor housing (002).
▪ Place the compressor housing (002) onto the intermediate flange (026).
▪ Align the holes of the compressor housing (002) and intermediate flange (026).
▪ Press the dowel pin (071) into the corresponding drill hole of the compressor
housing (002) as far as it will go.
▪ Put the washers (024) onto the screws (025).
▪ Put medium strength threadlocker onto the thread of the screw (025).
▪ Screw the compressor housing (002) and the intermediate flange (026) to-
gether with screws (025) washers (128) and nuts (028).
41 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Mounting 9
09.2013 · 610.44495.40.330