Assembly Of The Integrated Frequency Inverter - 2Fc4 - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
11.6 Assembly of the integrated frequency inverter - 2FC4...-1NE
▪ Mount the buffer (635), if provided, on the adapter plate (648).
▪ Place the gasket (641) on the terminal box opening of the motor housing (001).
▪ Place the adapter plate (648) on the gasket (641) with an overhang on the ven-
tilation side.
▪ Insert the screws (642) into the holes of the adapter plate (648) and screw
them to the terminal box in the motor housing (001).
▪ Position the terminal board (650) on the adapter plate (648).
▪ Apply medium strength threadlocker to the screw (651) and insert through
hole of the terminal board (650).
▪ Screw the terminal board (650) and the adapter plate (648) in using the screw
(651).
▪ Insert the seal (681), if provided, suitably into the recess of the adapter plate
(648).
▪ Position the housing trough (639) on the adapter plate (648) with an overhang
on the ventilation side.
▪ Apply medium strength threadlocker to the screws (637 and 638) and insert
through the hole of the housing trough (639).
▪ Screw the housing trough (639) and the adapter plate (648) in using screws
(637 and 638).
M = 3.1 – 3.5 Nm (2.29 – 2.58 ft lbs)
A
▪ Wire the electrical connections to the terminal board (650) and the housing
trough (639) according to the marks or the circuit diagram (e.g. cable kit,
earthing).
▪ Position the module carrier (698) on the housing trough (639).
▪ Screw the module carrier (698) and housing trough (639) using screws (699) .
M = 0.8 – 1.1 Nm (0.60 – 0.81 ft lbs)
A
▪ Place the module (646) or (647) at an angle and snap it into place in the
bracket of the module carrier (698).
▪ Wire all electrical connections to the module (646) or (647) according to the
marks or the circuit diagram.
▪ Position the frequency inverter (600) on the housing trough (639) with an over-
hang on the ventilation side.
▪ Screw the frequency inverter (600) and the housing trough (639) using screws
(682).
M = 3.1 – 3.5 Nm (2.29 – 2.58 ft lbs)
A
Complete the assembly using Testing [➙ 66].
Assembly options
65 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
11
09.2013 · 610.44495.40.330