Fitting The Compressor Cover - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.9

Fitting the compressor cover

▪ Fill the cavity of the bearing mount in the compressor cover (030) with grease,
according to the following table.
Motor size
2BH20360-3
2BH20540-3
2BH20780-3
▪ Turn the locating pin (X) into the bearing cover (010) and mount the compres-
sor cover (030) on the locating pin.
NOTICE! Note the position of the compressor cover (030) with respect to
the centre body (072).
▪ Put medium strength threadlocker onto the hexagon cap nuts (070).
▪ Screw the hexagon cap nuts (070) as far as they will go on the threaded studs
(074).
▪ Put the washers (076) onto the threaded studs (074).
▪ Fit the compressor cover (030) onto the centre body (072) and compressor
housing (002) using threaded studs (074), washers (076) and hexagon cap
nuts (070).
▪ Screw the bearing cover (010) and compressor cover (030) using the screw
(014).
Remove the locating pin (X) before fitting the last screw.
[g]
23.4 – 27.0
26.3 – 30.4
56.2 – 64.8
49 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Mounting 9
[oz]
0.826 – 0.952
0.927 – 1.072
1.983 – 2.285
09.2013 · 610.44495.40.330