Elmo Rietschle 2BH20360-3 Instandsetzungsanleitung Seite 114

9 Mounting
610.44495.40.330 · 09.2013
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
▪ NOTICE! Note the installation position of the impeller (027)!
▪ Place the impeller marked 2 (027) on the rotor (005).
▪ Push the sleeve marked 1 (134) onto the rotor (005) as far as it will go.
▪ Fill the new radial shaft seal ring (097) with grease to 100% and grease the
seat of the radial shaft seal ring in the centre body (072).
▪ Grease the entire surface of the sealing lip of the radial shaft seal ring (097) us-
ing a brush.
▪ NOTICE! Note the installation position of the radial shaft seal ring (097)!
▪ Insert the radial shaft seal (097) into the centre body (072).
▪ NOTICE! Note the installation position of the centre body (072)!
▪ Place on the compressor housing (002) with 1 marked centre bodies (072).
▪ Align the holes of the centre body (072) and the holes of the compressor hous-
ing (002).
Centre body (072) engages in the dowel pin (071).
46 / 67
© Gardner Denver Deutschland GmbH
Tel. 071 918 60 60, Mail: v-g@prematic.ch