Disassembly Of The Centre Body 1 And Impeller 2 - Elmo Rietschle 2Bh20360-3 Instandsetzungsanleitung

8 Disassembly
610.44495.40.330 · 09.2013
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
8.6

Disassembly of the centre body 1 and impeller 2

▪ Mark centre body (072) as centre body 1.
▪ Carefully loosen the centre body (072) using a flat-bladed screwdriver and pull
it off.
▪ Remove the dowel pin (071).
▪ Remove the radial shaft seal (097) from the centre body (072) and note the in-
stallation position.
▪ Pull the sleeve (134) off and mark as sleeve 1.
▪ Mark the installation position (blade direction) of the impeller (027) for later as-
sembly.
▪ Mark the impeller (027) as impeller 2.
▪ Pull the impeller (027) off.
▪ Remove the feather key (006) using a pair of pliers.
32 / 67
Tel. 071 918 60 60, Mail: v-g@prematic.ch
© Gardner Denver Deutschland GmbH