Adjusting The Product; Turning The Product On / Off - LIVARNO LUX ZD012C100130EU Bedienungs- Und Sicherheitshinweise

N ever direct the LED light beam on to reflective surfaces or at peo-
ple or animals. Failure to observe this advice may result in eye in-
jury and / or loss of sight to people or animals. Even a weak LED
light beam can cause eye damage.
P lace the product on a flat surface with its back side facing you.
I nsert the connection plug of the mains adapter
nection socket
P lug the mains adapter

Adjusting the product

Note: Only change the alignment of the product when it is turned off.
Y ou can adjust the product to the lighting conditions you require.
To do so, use the four joints:
1. Turning joint with lamp base
approx. 22.5° in both directions from the midpoint.
2. Lower tilt joint: with this you can move the lamp arm
90° upwards or downwards.
3. Upper tilt joint: with this you can move the lamp head
approx. 135° upwards or downwards.
4. Turning joint in the lamp head
head 90° in both directions.
1

Turning the product on / off

T o switch on the product, press the ON / OFF button
lamp base
6
on the back of the product.
7
into a properly installed socket.
9
6
.
: the lamp arm
: with this you can turn the lamp
1
into the con-
9
can be turned
2
approx.
2
1
on the
3
GB/IE 23