Presetting Stations - Yamaha RX-V620RDS Bedienungsanleitung

TUNING

Presetting Stations

I Automatically presetting stations
(for RDS stations)
You can use the automatic preset tuning feature to store
RDS stations. This function enables the unit to
automatically tune in to RDS stations with strong signals,
and to store up to 40 (8 stations x 5 groups) of those
stations in order. This feature enables you to easily tune in
to any preset station by selecting the preset station
number (see "Tuning in to a Preset Station").
D I G I T A L
STANDBY SURROUND
/ON
BASS BASS TREBLE SPEAKERS
EXTENSION DSP
A B EFFECT PROGRAM
+ +
ON OFF – – ON OFF
PHONES S VIDEO
SILENT
1
Press FM/AM to select the FM band.
FM/AM
2
Press TUNING MODE (AUTO/MAN'L MONO)
so that the "AUTO" indicator lights up on the
front panel display.
TUNING
MODE
AUTO/MAN'L MONO
3
Press and hold MEMORY (MAN'L/AUTO FM)
for more than 3 seconds.
The preset number, the "MEMORY" and "AUTO"
indicators flash. Then, after about 5 seconds,
automatic preset tuning begins from the frequency
currently displayed toward the higher frequencies.
MEMORY
MAN'L/AUTO FM
V-AUX VCR2/DVR VCR 1 D-TV/CBL
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
32
VOLUME
D I G I T A L
RDS MODE/FREQ EON
PTY SEEK
MODE START
INPUT MODE
INPUT
PRESET TUNING
/TUNING FM/AM MEMORY
MODE
EDIT MAN'L/AUTO FM AUTO/MAN'L MONO
VIDEO L AUDIO R OPTICAL
VIDEO AUX
1
3 2
AUTO
Lights up
DVD MD/CD-R TUNER
AUTO MEMORY
VOLUME
Notes
• Any stored station data existing under a preset number is
cleared when you store a new station under that preset
number.
• The reception mode is stored along with the station
frequency.
• You can manually replace a preset station with another FM or
AM station by simply following the procedure in the section
"Manually presetting stations".
• If the number of the received stations does not reach E8,
automatic preset tuning has automatically stopped after
searching all stations.
• Only RDS stations with sufficient signal strength are stored
automatically by automatic preset tuning. If the station you
want to store is weak in signal strength, tune in to it manually
in the monaural mode, and store it by following the procedure
in "Manually presetting stations". (There may be a case that
this unit cannot receive a station which could be received by
6CH INPUT
using the automatic tuning method. This is because this unit
receives a large amount of PI (Program Identification) data
along with the station.)
Automatic preset tuning options
You can select the preset number from which the unit
will store RDS stations and/or begin tuning toward
lower frequencies. Before automatic preset tuning
begins (after pressing MEMORY in step 3):
1. Turn the multi jog knob to select the preset number
under which the first station will be stored.
Automatic preset tuning will stop when stations have
all been stored up to E8.
2. Press PRESET/TUNING (EDIT) to turn off " z " and
then turn the multi jog knob to the left to begin
tuning toward lower frequencies.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the preset stations may be cleared. If
so, store the stations again by using the presetting
station methods.