Agrident AWR300 Bedienungsanleitung Seite 8

AWR300 Quick Start Guide
The status LEDs above the display
4.2
The AWR300 has two status LEDs above the display.
RGB
The RGB LED on the left side indicates the charging status of the battery pack as follows:
Color
The multicolor LEDs are only used when the AWR300 is turned off. When switched on, the battery
symbol in the display indicates the charging status.
The blue LED on the right side is only used when the display is turned off. Then it indicates the
following operating modes:
Color
The multicolor LEDs at the tip
4.3
The AWR300 has multicolor LEDs at the end of the reader. They allow to indicate the reading
status when the device is pointing into the direction of the transponder and where it might not be
possible to look at the readers display.
Color
12/09/16
Blue
The left LED is a multicolor type and thus the color can
change depending on the charging status. The LED
on the right is blue and it is used for indicating the
connection status.
Interval
Flashing, every seconds for 10ms
Solid
Interval
Flashing every 3 seconds
Flashing once a second
Interval
Flashing slowly
Flashing fast
Flashing fast
Battery is being charged
Battery is fully charged
Meaning
AWR300 is in SD-Card-Mode
AWR300 is in Suspend-Mode (CDC)
Meaning
RF is activated, ready to scan tags
Tag has been read the first time (new tag)
Tag has been read repeatedly (duplicate)
Meaning
Page 8 of 9