Tasks - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual

Tasks

7.3
This submenu is only visible if Task-Definitions have been uploaded. Such definitions are usually
very much dependent on the application and thus Agrident cannot provide them. They are
normally provided by distributors who also offer Management-Software that supports Agrident
Handheld readers. If no Task-Definitions have been uploaded, this menu item will not be shown
at all. Please contact your local distributor for further details about Task-Mode.
If Task-Definitions are present on the AWR300, this menu item will be visible automatically. When
entering the submenu 'Tasks', the following entries are shown:
A new Task is started via 'Start New Control'. Basically the user can switch from one data field to
the next one by simply pressing
inserting data depends on the field types which are used in the Task-Definition. This manual will
just show some examples. For further details please contact you distributor, who provided the
Task-Definitions.
09/03/18
Start New Control: Create a new record for the currently
selected Task
Show Memory Info: Shows the amount of records for the
currently selected Task and the number of possible
remaining records (maximum 10.000 per Task)
Choose another Task: Select a different Task definition
Browse Task Data: View the collected records (only
possible if allowed per definition; same for editing Task
data)
If 'Choose Another Task' was selected, the reader is listing
all available Tasks plus the amount of records in brackets
for each Task.
Navigate to the desired Task by using the
select the Task to use by pressing
after the correct data have been inserted. The method for
This is a List-Field.
... One item down
... One item up
... Scroll down one page
... Scroll up one page
... Select item
Here is a Numeric-Input-Field.
... Increase number
... Decrease number
... Next digit
... Previous Digit
... Confirm input
/ keys and
.
Page 21 of 49