Setup - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual
Choose a device from the list and select it by pressing
the Bluetooth printer and will try to connect to it for all coming print jobs until a different device
has been selected.

Setup

7.6
The AWR300 is very flexible concerning its configuration. Several settings can be adjusted
directly in the device menu. However, it does not make sense to allow the adjustment of all
possible reader settings on the device itself – this would make the menu structure far too
complicated. Settings which cannot be modified on the AWR300 itself, are software-adjustable.
A possible software for altering all possible AWR300 settings is AWR-PC-Demo. But generally
Agrident strongly recommends the use of professional management software since the Agrident
provided software is just meant to be used for configuration and demonstration purposes.
The setup menu is divided into several other menus and submenus, which will be explained in
this chapter. The overview of the complete menu structure is explained in chapter 7.1.
09/03/18
If Bluetooth is switched off, the AWR300 shows the
corresponding error message. In this case please activate
Bluetooth first (see chapter 7.6.3.4)
After the scan has been completed, the available devices
are listed. Please note that not only printers are listed here,
but also other Bluetooth devices. So ideally you should
know the device name of your Bluetooth printer.
Sometimes it might be useful to see the BD-address of the
found devices instead of the names. You may switch
between both views by using the
Now you can see the list of discovered devices with their
BD-addresses instead of the device names. Very often, the
BD-address can be found somewhere on a label of a
Bluetooth device. Since this address is unique, it can
quickly help to identify the correct device.
. The AWR300 will store this device as
key.
Page 31 of 49