Reader Settings; Animal Counter On/Off; Set Read Mode - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual

7.6.1 Reader Settings

7.6.1.1 Animal Counter On/Off

The animal counter decides about the question, if double reads are saved or not. A double read
occurs if a tag with one and the same EID is read within the same group again. When the animal
counter is activated, it is not possible to store the same EID within the same group again. If not
activated, it is possible to do that - the AWR300 does not check for double reads then.
The display also looks different after reading a transponder depending on how this settings is
configured:
Animal Counter = off
When the Animal Counter is not activated, the current group and the number of records in this
group is shown but the records can also include duplicate EIDs. When the Animal Counter is
activated, the displays shows 'Animals' instead of 'Records' – duplicates are not possible here.

7.6.1.2 Set Read Mode

Per factory defaults, the AWR300 is configured to 'Single Read'. This means that RFID is
activated until a transponder has been detected or the 'Single Read Time' (default = 10 seconds)
has elapsed. The
The AWR300 also allows to use the 'Continuous Read' mode. The RFID engine will not be de-
activated after a tag has been read. It will continue scanning until the 'Continuous Read Time'
(default = 60 seconds) has elapsed. Every new tag read resets this timeout.
The setting 'Auto' will start a Single Read on a short press of
long press ( > one second).
09/03/18
Decide whether the Animal Counter should be activated or
not using the
key has to be pressed in order to scan for tags again.
Select the Read Mode using the
confirm with
/ / / keys and confirm with
Animal Counter = on
/
.
and Continuous Reading on a
.
/ / keys and
Page 32 of 49