New Group - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual
st
Main Menu 1
Setup Configuration
Device Info

New Group

7.2
In the memory of the AWR300, records are organized in groups. One group can contain up to
10.000 records maximum. A new record is created for every transponder which has been read. If
you do not wish to create new records for duplicate reads, please enable the 'Animal Counter' –
then duplicates will not be saved again within one group (see chapter 7.6.1.1)
After 10.000 records within one group the device will force the user to create a
new group – even if groups are not required for a particular application. But this
only means one press of one key in the simplest case (confirm suggested group
name by pressing
If no group has been created manually before the first transponder was read, the
device will insert a group with the default name 'Group 1' automatically. If the
name of the first group should be different, the user must insert a group before
scanning for transponders.
09/03/18
nd
sub menu 2 submenu
Set Factory Configuration
Set Custom Configuration
Show Battery Info
Show Firmware Info
After 'New Group' was selected, the user will be prompted
to insert a group name. At this stage the suggested name
can be accepted by pressing
pressing the left soft key character by character. A long
press removes all digits in one step. By pressing
the device will open a soft keyboard which is shown in the
display...
The user can navigate to letters, numbers or symbols and
paste the desired character into the group name by using
the
content can be switched (capitals & special characters).
After the new group name has been entered completely,
press the right soft key (here: 'close') in order to exit the
soft keyboard. Now the name can be checked again and
it will be confirmed by pressing
from now on will be saved in this group (max. 10.000).
).
rd
3 submenu
key . By pressing the left soft key the keyboard
th
4 submenu
or it can be deleted by
or
. All transponders read
Page 20 of 49