Configuration; Set Factory Configuration; Device Info; Show Battery Info - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual

7.6.4 Configuration

7.6.4.1 Set Factory Configuration

7.6.5 Device Info

7.6.5.1 Show Battery Info

09/03/18
After selecting 'Configuration', the menu shown on the left
side will be displayed.
'Set Factory Configuration' puts all settings back to the
factory default values. This might be useful if particular
settings have been changed and the AWR300 is not
operating as intended anymore. Please note that this action
cannot be undone. Settings different from the factory
defaults have to be made again.
...confirm reset
... abort reset
The menu 'Device Info' includes items showing information
about the current battery status, the AWR300 firmware and
some information on the hardware.
When fully charged, the battery info shows '100%'.
Below the charging indication, the display shows rough
estimates concerning the remaining operating time in
standby mode (AWR300 running but RFID engine is off),
here 33hours, and in continuous read mode, here 10 hours.
Page 44 of 49