Bluetooth - Agrident AWR300 Bedienungsanleitung

AWR300 User Manual

7.6.3.4 Bluetooth

The AWR300 always incorporates a Class1 Bluetooth module. The range is up to 80 meters in
'line of sight'. Inside buildings or when any other obstacles are present, it will be less. Please note
that the range also depends on the Bluetooth partner. If the other device is only Class2, the range
is much lower. This especially applies to devices like smart phones.
There are several menu items for Bluetooth, which will be explained in this chapter.
The Bluetooth Mode determines if the AWR300 should initiate the connection to another device
(Master Mode) or if other devices should be able to connect to the AWR300. Per default, Bluetooth
is not activated (OFF), so it must be switched on first. Then you have to decide whether the
AWR300 should be the device initiating the connection (Master) or the other device (Slave).
When the AWR300 is in Master Mode, it needs to know the address of the intended Bluetooth
partner, also called 'remote device'. An easy way to find out this address is to scan for Bluetooth
devices in range. Make sure the other device has Bluetooth activated, that it is 'discoverable' and
'connectable' and that it is in range. For smart phones, for example, it is normally required to
make them discoverable first, usually for a particular time. This can be done in the phones
Bluetooth settings. If this has been done, select 'Start BT Inquiry' and press
09/03/18
The Bluetooth menu contains the items shown on the left
side.
... One item down / up
/
... Switch to first / last item
/
... Enter submenu resp. start action (BT Inquiry)
Select the desired Bluetooth Mode using the
keys and confirm with
The AWR300 starts scanning for other Bluetooth devices
in range. This can take quite a long time, also depending
on how many devices are found, but at least 10 seconds.
/
.
.
/ /
Page 38 of 49