After Use - Concept ZN 8010 Bedienungsanleitung

UK
ELECTRONIC SAFETY AUTO - OFF INDICATOR
(available on model ZN 8030 only)
The steam iron has an Electronic Safety Auto-Off indicator which will turn the iron off
should the iron remain motionless either in the upright position for approximately 15
minutes or flat on the soleplate for approximately 30 seconds. In such instances the
power to the iron will automatically be switched off and the Auto-Off indicator light will
flash whilst a warning beep will sound.
Slight movement of the iron will reset the power.

AFTER USE

- Set the steam selector knob to „DRY".
- Disconnect from the mains supply.
- Open the water filling inlet cover.
- Invert iron and shake the iron to empty the water tank, and then stand the iron in an
upright position to allow to cool.
- In order to save space, the power cord may be easily wound around the cord
stowage facility after the iron has cooled.
- Always store the iron (with water empted from water tank) on its heel rest, not on the
soleplate. Even the smallest amount of moisture will cause corrosion and staining of
the soleplate if the iron is stored with the soleplate facing downwards.
SELF-CLEANING
Your iron will give the best ironing results and last longer if you apply self-cleaning
regularly (once or twice a month) to remove any scale or fluff.
- Set the steam selector knob to „DRY" position.
- Fill the water tank up to „MAX" water level with water filling beaker supplied.
- Place the iron on its heel.
- Set the temperature dial to „LINEN".
- Plug into the mains supply and switch on at the socket.
- Allow the iron to heat up until the heating indicator light first goes out and then
comes on again.
- Remove the plug from the wall socket.
- Hold the iron horizontally over the sink.
- Set the steam selector knob at position „CLEAN" and carefully pull up the steam
selector knob so that it rests in this position.
- Caution: When the steam selector knob is pulled up, boiling water and steam will
emit from the holes in the soleplate and wash away the impurities and scale.
- Move the iron forwards and backwards while this happens. Go on letting steam and
water escape until the water tank is virtually empty.
48 ZN 8010, ZN 8020, ZN 8030