Filling With Water - Concept ZN 8010 Bedienungsanleitung

UK

FILLING WITH WATER

- First ensure that the iron is disconnected from the electricity supply before filling with
water.
- Set the Steam Selector to position „DRY".
- Open the water filling inlet cover, use the water filling beaker supplied to pour water
slowly into the filling hole.
- NOTE: Tap water can be used (see below: „A Special Note on Water").
- Push firmly to close the water filling inlet cover.
- During the ironing process, always ensure there is sufficient water in the water tank.
* A special note on water:
Water containing sediments and alkalis will cause the steam holes and internal workings
of the iron to fur. The specially designed steam chamber and the anti-scaling valve,
which is removable for cleaning, gives your steam iron protection against furring. You
can use tap water in your iron.
To guarantee the maximum life-time of your steam iron:
- Do not use chemically descaled water.
- The harder the water the more the iron should be self-cleaned (see section
„Maintenance").
ANTI-CALC FILTER
The built-in anti-calc filter is designed to reduce the build-up of lime scale which occurs
during steam ironing, this will prolong the working life of your iron. However, please note
that the anti-calc filter will not completely stop the natural process of lime scale build-
up.
46 ZN 8010, ZN 8020, ZN 8030