Concept ZN 8010 Bedienungsanleitung Seite 50

Important:
Only pull out the steam selector knob when you want to activate the self-cleaning
system. Never pull out the s team selector knob when ironing.
CLEANING THE REMOVABLE STEAM VALVE
- In addition to the self- cleaning operation, we advise cleaning the steam valve once
a month (e.g. whenever steam development is insufficient). The steam valve is
located at the lower end of the steam selector knob.
- Before removing and cleaning the steam valve unplug the iron and empty the water
tank.
- Carefully pull out the steam selector knob. Do not touch the steam valve at its lower
End.
- Immerse the steam valve in vinegar (not vinegar essence) for 4 hours until the lime
becomes soft. Using a non-metallic brush to remove remaining residues, then rinse
under running water. Do not use sharp objects for cleaning the steam valve.
- Press the steam selector knob down and turn it anti-clockwise to set it to position
„DRY".
- Set the steam selector knob on mark CLEAN again. (align with the small notch at the
side part).
- Insert the plug into the wall socket.
- Set the temperature dial to position „LINEN". Let their on heat up again. The
remainder of the water inside the steam chamber will now vaporize.
- Unplug from power supply and allow soleplate to cool and wipe it clean with a soft
damp cloth.
ZN 8010, ZN 8020, ZN 8030
UK
49